Author Topic: Tower sight bug visualized  (Read 4199 times)

Offline NPSH

  • Critter
  • *
  • Posts: 1
    • View Profile
Tower sight bug visualized
« on: August 06, 2023, 08:23:20 AM »
Hi there, I haven't seen any good posts explaining the tower sight bug, so I'm going to show it myself.

Warcraft II's sight radius is always measured from a sight center point (red square on the red tower).

Since a tower is 2x2 there's no exact middle point, the lower right corner is set as center of sight.
This causes the following: a tower sees 9 units to the right and below, but since there's a piece of tower above and left to it, it sees only 8 units!

This has the consequence that a tower will see another tower 9 units below it but won't see a tower 9 units above it.

This sight bug also applies to the Farm (2x2 units, sight 3 units) and the Hall (4x4 units, sight 5 units) but since the sight area of these are smaller, it does not make much difference.
« Last Edit: August 06, 2023, 09:12:52 AM by NPSH »

Offline 123Bee

  • Peon
  • **
  • Posts: 11
    • View Profile
Re: Tower sight bug visualized
« Reply #1 on: August 28, 2023, 08:14:43 PM »
Thanks very much for your work sir